ALMiG

ALMIG AIR CONTROL III

This controller is installed on all compressors bigger than 50 hp and the whole VARIABLE speed range as standard.

ALMIG AIR CONTROL 3 is the most advanced controller series and can be used for any type of compressor + other brands. With the integrated sequencer for controlling up to 8 compressors no matter which brand they can be in lead / lag operation. Furthermore the system is ready for connection to a factory wide data bus.

Features:

• Integrated microprocessor controller "ALMIG AIR CONTROL 3"
• System optimizer for lowest power consumption
• Pressure optimizer for +/- 2 psi constant pressure
• Very easy to operate
• VSD soft start feature to avoid power peaks during startup
• All electric connections tagged for easy maintenance
• Customer and service passwords for best system security against misuse
• RPM percentage monitor
• Pre alarm system for scheduling the preventive maintenance
• Safety functions with automatic shut-down before damage
• Monitor for temperature, main motor, fan motor, drive and system pressure
• Service hour counter for air filter, oil, oil filter and fine separator
• Automatic restart after power loss
• Remote start and stop features
• Can be updated at any time
• Self-test of the compressor before every start-up for
• 7 input  / output timers for digital switching (on / off)
• 7 timers for the pressure reduction

The hardware of the controller components:

• Advanced high performance microcontroller design
• Keypad with five buttons for switching the compressor ON and OFF as well as programming set points and parameters.
• Direct access to the VSD parameters
• LCD display to monitor instantaneous all parameters and their set points, actual status, pressure, temperature, faults or warnings
• High speed digital signal processor
• Digital inputs to monitor external accessories like dryers or filters
• Digital outputs to control external accessories like dryers, fans, heating devices, etc.
• Remote start stop interface
• All parameters and set points are protected with an automatic backup before shutdown.

The illuminated LCD Display (monitor in the format 2.5 x 4.5 inch, 240 x 128 Pixels) offers a continuous plaintext display of all important parameters of operation:

• Operation status
• Text is in English language which makes it easy to read and program(No cryptic codes used!)
• The 16 most important parameters are shown on the main screen by pressing the menu button.
• Permanent display of the actual network pressure
• Permanent display of the compressor temperature
• Permanent display of the idle times and internal pressure
• Temperature shown in °F and pressure in psi as well as in metric units
• Date / real-time clock
• 1 red LED to display pre-alarms and faults

The built-in monitor can display operating diagrams e.g. :

• Utilization of the compressor
  • total operating hours
  • full load hours
  • idle times
  • shutdown times
  • VSD percentage
• Pressure diagram
• Temperature diagram
• Produced cfm of air
  
  • daily profile
  • weekly profile
• Service intervals / hours