|
ALMIG AIR CONTROL II
ALMIG AIR CONTROL 2 is the basic controller for the FLEX 6 - 30 series and can not be used for any other type of compressor or other brands.
Features:
- Integrated microprocessor controller "ALMIG AIR CONTROL 2"
- System optimizer for lowest power consumption
- Pressure optimizer for +/- 2 psi constant network pressure
- Very easy to operate
- VSD soft start feature to avoid power peaks during startup
- All electric connections tagged for easy maintenance
- Customer and service passwords for best system security against misuse
- RPM percentage monitor
- Pre alarm system for scheduling the preventive maintenance
- Safety functions with automatic shut-down before damage
- Monitor for temperature, main motor, fan motor, drive and system pressure
- Service hour counter for air filter, oil, oil filter and fine separator
- Automatic restart after power loss
- Remote start and stop features
- Can be updated at any time
The hardware of the controller components:
- Advanced high performance microcontroller design
- Keypad with five buttons for switching the compressor ON and OFF as well as programming set points and parameters.
- LCD display to monitor instantaneous all parameters and their set points, actual status, pressure, temperature, faults or warnings
- High speed digital signal processor
- Digital inputs to monitor external accessories like dryers or filters
- Digital outputs to control external accessories like dryers, fans, heating devices, etc.
- All parameters and set points are protected with an automatic backup before shutdown.
Backlight dot matrix LC-display showing:
- Operation status
- The 16 most important parameters are shown on the main screen by pressing the info button.
- Permanent display of the actual network pressure
- Permanent display of the compressor temperature
- Permanent display of the idle times and internal pressure
- Temperature shown in °F and pressure in psi as well as in metric units
- 1 red LED to display pre-alarms and faults
|
