ALMiG

ALMIG AIR CONTROL I

This controller is installed on the BELT, DIRECT and GEAR series up to 75hp as standard. All compressors with Air Control 1 can be upgraded to AIR CONTROL 3.

ALMIG AIR CONTROL 1 is the basic controller for the fixed speed compressors up to 75hp and can be installed on any other compressor on the market. What makes it unique is the fact that the controller itself is very simple to operate. With the integrated sequencer it is possible to operate together with ALMiG AIR CONTROL III as in lead/lag operation.

Features:

• Integrated microprocessor controller "ALMIG AIR CONTROL 1"
• State of the art microprocessor
• System optimizer for lowest power consumption
• Very easy to operate
• Prepared for sequencer operation (lead/lag control) through a bus system.
• Y – Delta or VSD optimizer for reduced power peaks during motor start
• No Load optimizer for reduced energy consumption by calculating the shortest possible idling operation
• Automatic selection of the most economic operation mode to reduce energy consumption
• All electric connections tagged for easy maintenance
• Customer and service passwords for best system security against misuse
• Pre alarm system for scheduling the preventive maintenance
• Safety functions with automatic shut-down before damage
• Monitor for temperature, main motor, fan motor, drive and system pressure
• Service hour counter for air filter, oil, oil filter and fine separator
• Automatic restart after power loss
• Remote start and stop features
• Can be updated at any time

The hardware of the controller components:

• Advanced high performance microcontroller design
• Ruggedized Keypad with buttons for switching the compressor ON and OFF as well as programming set points and parameters.
• LCD display to monitor instantaneous all parameters and their set points, actual status, pressure, temperature, faults or warnings
• High speed digital signal processor
• Remote start stop interface
• RS485 Bus system
• All parameters and set points are protected with an automatic backup before shutdown.

Backlight dot matrix LC-display showing:

• System in operation
• System @ standby
• System @ full load
• Remote control status
• Automatic restart after loss of power
• Network pressure
• Air and Oil temperature
• Pre alarms
• and many more...